Horizontal Wind Turbine
The TPW Series Wind Turbines from Tycon Power Systems are lightweight at less than 10.5kg and are designed for ease of installation and long service life. The generator is a very low cogging force design for better performance in light winds and is packaged in a fully sealed die cast anodized aluminum enclosure. There are no brushes to wear out or cause electrical noise and the bearings are sealed so the system is maintenance free. The blades are glass reinforced nylon for high strength, UV resistance and fatigue resistance. The turbines are available in a 12V/24V auto voltage select model. The unit includes a smart battery charge controller and dump load resistor. The dump load helps prevent premature braking and increases the total power delivered to the batteries. The entire blade assembly can be removed easily as 1 piece for hurricane protection. This also makes it easier and safer to install.
The permanent magnets used are Neodymium Iron Boron (NdFeB) for higher power output.
The mounting is to the inside of the top of a 41mm ID standard pole. The hardware used is stainless steel for corrosion protection.
This product was added to our catalog on Tuesday 20 August, 2013.